Filter
Top Products
186
Menu: Menu Description Tables
Note
The safety zone marker, the safety zone area, and the frame
marker are not displayed on the LCD monitor if “LT-BOX” is
selected in DOWNCON MODE.
The user box can be displayed in any position as a
boxtype cursor.
Note
The user box is not displayed on the LCD monitor if “LT-
BOX” is selected in DOWNCON MODE.
VF MARKER
Items/
Data Saved
Adjustable
Range
Remarks
TABLE A
B
Select the VF MARKER setting table.
First, select table “A” or “B”, then set the
items below for each table.
–CUFR
CENTER MARK OFF
1
2
3
4
Switch the center mark.
OFF: Do not display center mark.
1: + (large)
2: Hollow (large)
3: + (small)
4: Hollow (small)
–CUFR
SAFETY MARK OFF
1
2
Select the frame type for the safety zone.
OFF: Do not display frame.
1: Box
2: Corner frame
–CUFR
SAFETY AREA 80%
:
90%
:
100%
For setting the size of the safety marker.
It is possible to set the size by units of
1% with a fixed ratio between of width
and height.
–CUFR
FRAME MARK ON
OFF
Set the frame marker to “ON” or “OFF”.
–CUFR
FRAME SIG 4:3
13:9
14:9
VISTA
CNSCO
Set the frame marker.
The VISTA ratio is 16:8.65. (1.85:1)
The CNSCO ratio is 16:6.81 (2.35:1).
–CUFR
FRAME LVL 0
:
15
Set the level outside the frame marker.
Note that the level does not change on
the LCD monitor.
0: Equivalent to signal off.
(Blanking status)
15: Same brightness as center area.
–CUFR
VF USER BOX
Items/
Data Saved
Adjustable
Range
Remarks
USER BOX ON
OFF
For setting whether the user box is
displayed in the viewfinder or not.
–CUFR
USER BOX
WIDTH
1
:
13
:
100
For setting the width of the user box.
–CUFR
USER BOX
HEIGHT
1
:
13
:
100
For setting the height of the user box.
–CUFR
USER BOX H
POS
–50
:
+00
:
+50
For setting the horizontal position of the
user box center.
–CUFR
USER BOX V
POS
–50
:
+00
:
+50
For setting the vertical position of the
user box center.
–CUFR
AJ-HPX3700G-VQT1V68_eng.book 186 ページ ２００８年１０月１５日 水曜日 午後６時３８分