Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 11 of 71
Mar 02, 2015
Figure 1.8 [Save As] Dialog Box of HEX Editor
Besides the file name and folder location, a start address and an end address for the new file can be selected in the [Save
As] dialog box. The original start address and end address are displayed by default. Select the file radio button for the
format in which to save the data. Select the same format as that of the loaded file. Use of the saved file with other tool
products is not supported.
Note Mapping of the data flash memory may differ between normal operation and flash memory programming mode.
Refer to the user’s manual of the MCU for more information on mapping when the flash memory programming
mode is selected.
(2) [Upload from FP5...] command
The [Upload from FP5...] command is used to upload the program file, PR5 file and ESF file saved in a valid
programming area.