Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 12 of 71
Mar 02, 2015
Figure 1.9 [Upload from FP5...] Dialog Box
<1> [Upload program file from FP5] button
The storage location and file name of the program file are specified in the HEX file: box. In order to change the file
location or name, click the Save as button and make the changes.
<2> [Upload Parameter/Setting files from FP5] button
The Parameter file: box specifies the storage location of the PR5 file. The Setting file: box specifies the ESF file
storage location and file name. In order to change the file locations, click the Save as button and make the changes.
The parameter file names cannot be changed.
<3> Address range selection area
This area is enabled with the [Upload program file from FP5] button clicked. Specify the address range of the program
file that is to be saved.
<4> Option area
When the [Show data] check box is checked, the action log window will be displayed when the upload is executed.
Pressing the OK button will start the upload with the selected settings.
Pressing the Cancel button will close the dialog box without executing the upload.
(3) [Checksum] command
The [Checksum] command calculates the checksum of the selected program file downloaded to FP5 and displays the
result. When this command is executed, the Checksum dialog box appears. Select the optional calculation method and
the target address range, and click the OK button. The result will then be displayed in the [File Checksum] area in the
action log window and programmer parameter window. This command can be executed after the [Setup] command is
executed. If the [Setup] command is executed again after the [Checksum] command is executed, the result displayed in
the [File Checksum] area in the programmer parameter window will be cleared.
<2>
<1>
<3>
<4>