Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 28 of 71
Mar 02, 2015
1.3.3. [Device] menu
The following pull-down menu appears by clicking the [Device] menu.
This menu includes commands mainly related to programming to the target device, such as erase, write and verify.
Figure 1.38 [Device] Menu
(1) [Blank check] command
The [Blank Check] command performs blank check for the flash memory in the target device. The target area can be
set in the [Operation Area] area on the [Advanced] tab in the Device Setup dialog box. If the flash memory has not yet
been written, “PASS” is displayed. If the flash memory has already been written, “ERROR(E051):Not Blank” is
displayed. If this error is displayed, erase the entire flash memory before starting programming.
(2) [Erase] command
The [Erase] command erases the flash memory in the target device. The target area can be set in the [Operation Area]
area on the [Advanced] tab in the Device Setup dialog box. While erasing the flash memory is in progress, the progress
status is displayed in the action log window. When execution of this command is completed, the result of command
execution in the target device is displayed. Whether to perform the Configuration Clear command after executing this
command depends on the [Configuration Clear after Erase] check box setting on the [Advanced] tab in the Device
Setup dialog box.