Filter
Top Products
PG-FP5 V2.13 PROGRAMMING GUI USAGE
R20UT2924EJ0200 Rev.2.00 Page 36 of 71
Mar 02, 2015
Figure 1.47 Device Setup Dialog Box - [Target] Tab
<1> [Programming Area Setting] area
The FP5 has a 16 MB flash memory area for saving program files. This memory area can be used as two programming
areas of 10 MB and 6 MB (Area 0 to Area 1), four 4 MB programming areas (Area 0 to Area 3) or eight independent 2
MB programming areas (Area 0 to Area 7). Program files can be downloaded to each programming area, and which file,
PR5 or ESF, is to be saved is selectable in programming area units. That is, files can be individually downloaded in each
programming area, and the area used can also be selected individually.
In this area, the factor for dividing the programming area can be selected. If the division factor is changed, data on the
programming area map is cleared. In addition, the valid programming area can be selected. If the valid programming
area is changed, the focused area in the [Programming area map] area is also changed. By default, the division factor is
set to 2 and programming area 0 is selected.
Figure 1.48 [Programming Area Setting] Area
[Division pattern] radio buttons
2 division (Area0:10MB/Area1:6MB): The division factor is set to 2 (10 MB area and 6 MB).
4 division (4 MB/DIV): The division factor is set to 4 (4 MB per area).
8 division (2 MB/DIV): The division factor is set to 8 (2 MB per area).
[Programming Area Setting] list
If “2 division (Area0:10MB/Area1:6MB)” is selected, the valid programming area is selected from areas 0 to 1.
If “4 division (4 MB/DIV)” is selected, the valid programming area is selected from areas 0 to 3.
If “8 division (2 MB/DIV)” is selected, the valid programming area is selected from areas 0 to 7.
<1>
<2>
<6>
<3>
<4>
<5>