Filter
Top Products
78
GB
Digital Photo Printer -DPP-FP50_GB_UC2/CED/CEK/AU_ 2-599-949-11(1)
Symptom
The image
cannot be
printed fully in
the print range.
Even if I set
“Borders” to
“No”, the image
is printed with
borders on both
sides.
Only part of an
image is printed.
The image is
stretched
horizontally
when printed.
There are white
lines or dots on
the printed
pictures.
Cause/Solutions
cSet “Borders” to “No” by selecting
Menu - Set Up - Borders. (.page
49)
cDepending on the type of digital
camera used, the aspect ratio of the
recorded image differs, so the image
may not be printed covering the entire
printable area.
c
When you edit and save an image in
the postcard or 3.5 x 5 inch size, it is
saved as a print image including the
blank areas. Even if you print it with
“Borders” set to “No”, you cannot
eliminate the borders on both sides of a
print. To print without borders, edit
and save an image with “Borders” set
to “No”. (.page 49)
cSet “Borders” to “Yes” to print the
whole area of an image. (.page 49)
cDepending on the type of digital
camera used, the image may be
stretched vertically if it has been
rotated or processed using your
digital camera. This is not because of
trouble with the printer, but because
the image was rewritten with your
digital camera.
cThe print head or paper path may be
soiled. Use the supplied cleaning
cartridge to clean the head and path.
(.page 89)
Check
• Did you set “Borders” in
the Set Up menu to
“Yes”?
• Is the aspect ratio of the
image correct?
• Is the image edited and
saved with “Borders” set
to “Yes”?
•
Did you set “Borders” in
the Set Up menu to
“Yes”?
• Did you rotate the image
or add other process?
001GBFP5012TRB-UC/CED.p65 3/11/05, 4:23 PM78