BASIC IMAGE RECORDING
71
To do this:
Have the flash fire automatically when
required (Auto Flash)*
Turn off the flash (Flash Off)
Always fire the flash (Flash On)
Always use soft flash, regardless of
exposure conditions (Soft Flash)
Fire a pre-flash followed by image
recording with flash, reducing the
chance of red-eye in the image (Red-
eye reduction)
In this case, the flash fires automatically
when required
Select this setting:
* appears momentarily when you select Auto as
the flash mode, and then disappears.
2.
Press the shutter button to record the image.
Flash mode indicator
Using the Flash
Perform the following steps to select the flash mode you
want to use.
• The approximate effective range of the flash is shown
below.
Wide Angle Optical Zoom:
Approximately 0.1 to 3.7 meters
(0.3´ to 12.1´) (ISO Sensitivity: Auto)
Telephoto Optical Zoom:
Approximately 0.6 to 1.9 meters
(2.0´ to 6.2´) (ISO Sensitivity: Auto)
*Depends on zoom factor.
1.
In the REC mode, press [̄] ( ).
• Each press of [̄] ( ) cycles through the flash
mode settings described below on the monitor
screen.
[
̄
] ( )