Filter
Top Products
ScanSnap S500 Operator's Guide xv
Protect the scanner from static electricity.
Do not use aerosol sprays near the scanner.
Avoid any contact when scanner is in use.
Unplug the power cord from the electrical outlet when the
scanner is not used for a long period of time.
Do not install the scanner in direct sunlight.
Do not use the scanner immediately after moving it from a cold
place into a warm room.
Be careful not to cut yourself
Install the scanner away from strong magnetic fields and other sources of
electronic noise. Also, protect the scanner from static electricity as this might
cause the scanner to malfunction.
Do not use aerosol sprays to clean the scanner. Aerosol sprays cause dirt and
dust to enter the scanner, resulting scanner failure and malfunction.
Avoid touching any scanner mechanism when scanning as this may cause
injuries.
For your safety, unplug the power cord from the electrical outlet when the
scanner is not used for a long period of time.
Do not install the scanner in direct sunlight or near heating apparatus. Doing so
might cause excessive heat to build up inside the scanner, causing fire or
scanner trouble. Install the scanner in a well-ventilated location.
Do not use the device immediately after moving it from a cold place into a warm
room. This may cause condensation, which might lead to scanning errors. Let the
device dry about one or two hours before you use it.
When handling paper or the Carrier Sheet, be careful not to cut yourself by the
paper or the Carrier Sheet.