Filter
Top Products
11
Figure 16. Memory screen ( Setup | Memory )
Passcode screen ( Setup | Passcode )
You can control who has access to the features of your dome by distributing passcodes that allow varying
degrees of access. The dome ships with no default passcodes. When you enter the programming interface for
the first time during installation and go to Setup | Passcode, the passcode fields are blank. Blank passcode
fields mean the passcodes are turned off (disabled). You can choose to enter passcodes into the blanks. This
turns passcodes on (enabled) and a passcode will be required to enter the programming interface the next time
you access it.
If no passcodes are programmed, all users are given installer access and are not required to log on. If only the
Admin and Operator passcodes are programmed, then anyone can still access the entire programming interface
as an installer, since the Installer passcode was not programmed.
CAUTION
CAUTION
Clearing memory replaces your custom programmed settings with the factory default settings.
Select memory (clear options) You can clear all or specific portions of your dome’s programming, which is
saved in the housing’s site-tied memory. After selecting an option, select Clear.
Choices are Clear all (default), Clear setup options, Clear presets,
Clear macros, Clear ShadowTours, Clear areas, Clear alarm actions, and
Clear privacy masks.
CAUTION
CAUTION
If using passcodes, record them in a secure place. If you forget the passcodes for a dome, you will need to
send the dome back to the factory so that it can be reset by the factory with no passcodes.