Filter
Top Products
3
Accessing the programming interface
If passcodes were turned on during installation or later, access to the programming interface will be passcode-
protected. You must log on to program the dome. Otherwise, you will be taken directly to the main
programming screen. The passcodes control who has access to the features of your dome. See Passcode screen
( Setup | Passcode ) on page 11.
The steps for accessing the programming interface from all GE keypads are similar. The following procedure is
based on the KTD-405 keypad, which is currently GE’s most popular keypad. Exceptions to the procedure for
other GE keypads are noted. You can also use the GE KTD-400 and KTD-404/304 keypads and other
manufacturers’ keypads and controllers using the PelcoD, Ultrak, Impac/485, and ASCII protocols. When
using these other protocols, all common commands used for accessing programming, operating the joystick
and iris key on the keypad, and controlling presets are supported by the Legend protocol. For an up-to-date list
of compatible keypads and protocols, please contact your GE sales representative or Technical Support.
To access the programming interface from a KTD-405 keypad:
1. At the normal display, press and hold the set
( ) key on the keypad until you hear a
beep and the programming code display
appears on the keypad’s LCD.
Figure 2. Normal display (visible before programming interface accessed)
2. At the enter programming code display, enter
the programming access code by pressing the
9, 5, 1, and seq keys.
This code is the same for all GE keypads.
Figure 3. Enter programming code display
3. At the equipment selection display, press 3 to
select CAMERA (Figure 4, keypad version
1.2.09 or later) or CAMERA/RCVR
(Figure 5, keypad version 1.1.06 or earlier).
If you have an older keypad (version
1.1.06 or earlier), you will have a second
equipment selection display, at which
you need to press 1 for CYBERDOME.
Figure 4. Equipment selection display (v1.2.09 or later)
Figure 5. Equipment selection display (v1.1.06 or earlier) Figure 6. Second equipment selection display for older keypads
CAMERA 1
MONITOR 1
ENTER PROGRAMMING
CODE: _
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA EXIT
!
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA/RCVR EXIT
!
1=CYBERDOME 2=PTZ
3=AUXILIARY
"BACK