Filter
Top Products
Legend
User Manual
66
• IP for domes: 192.168.208.XXX, where XXX is the site number (or camera address) of the
dome.
• Subnet mask for domes: 255.255.255.0
2. Copy the update file from the Legend system CD to your computer. It will usually be named in the
format of Legend.raw.gz with some variations.
3. Open Microsoft Internet Explorer.
4. Type your dome’s IP address into the address box in the form of
http://XXX.XXX.XXX.XXX/update.htm.
5. Press Enter or click Go.
10. At this point, ensure that the reload/update process is not interrupted. The unit is not safe to interact
with until after the system is successfully rebooted. Wait until after you see the splash and color bar
screens on the monitor screen, and live video is again showing normally.
You may see a blank or gray screen for up to five minutes. Do nothing until you see live video again.
Only after 10 minutes have elapsed without a successful reload/update can you try cycling power to
restart the dome.
6. If this is the first time you are accessing the
web browser for the dome after it has rebooted,
you will be asked to log on to the dome.
• Only installers have passcode
permission to update software.
• You need to type in Installer with a
capital letter I.
• Finally, you need to use the same
passcode as is used for accessing the
dome’s programming interface. Leave
the password box blank, if the Installer
passcode was not turned on for the
programming interface.
Figure 56. Legend web-based log in screen
7. At the Legend web based firmware update
page, enter the name of the firmware file, if
known, or click the Browse button to locate
the file.
8. If you are browsing for the file, once you
find it, click File | Open to populate the
filename entry on the previous page.
9. Click Send File.
Figure 57. Legend web based firmware update page