Filter
Top Products
Page 2
Software Use and Installation Introduction
Dual-Tap TM-4200CL AccuPiXEL Series Camera-Control Software
1.1.2 Installing the Software
To install the Dual-Tap AccuPiXEL series camera-control software, obtain the software from the JAI
web site and run “Setup.exe.” The installer will direct you to install the application code.
If dual tap software is already installed on your computer, uninstall the software using the steps in the
Uninstall section.
Note: The link to the frame grabber must be configured after the new software installation. The
program asks for the location.
1. To obtain the Dual Tap software visit the JAI PULNiX web site at http://www.jaipulnix.com
2. Click the Support link
3. Click the Software Downloads link under the Customer Support menu
4. Select the camera model number by clicking in the option button.
5. Select either Open or Save on the install dialog box
Note:The file is compressed, and uses the decompression program installed on your
computer. WinZip is used in this example.Windows XP has an unzip capability as part of
the operating system.
6. Open the file.
7. Double click on the Setup icon.
- It is not necessary to decompress the DualTapAccuPiXEL.CAB file
FIGURE 1. Setup installs Dual Tap AccuPIXel v 2.5.0
8. Follow the Setup instructions.