Filter
Top Products
Page 12
Graphical User Interface
Dual-Tap TM-4200CL AccuPiXEL Series Camera-Control Software
3.3.3 Gain Control
3.3.3 (a) Gain
Gain controls the brightness of an image. If the gain number is increased, (for example, 1000 to 2000)
the image becomes brighter. If the gain number is decreased, the image becomes dimmer. The Gain
Control box allows you to change the Gain value.
When R Auto Gain is checked the camera automatically sets the gain. While the camera is setting the
gain the user interface is disabled. Once the gain is set the checkbox clears. Be careful not to send other
configuration commands during this process because the camera may not receive the commands.
FIGURE 18. Gain is being set if the R Auto Gain box appears checked.
3.3.4 Offset Voltage
Offset is changed by raising on lowering the number in the “Master Offset” or “R Fine Offset” box
either by clicking on the arrows or typing a new value in the box.
Checking the “R Auto Offset” checkbox causes the camera to automatically adjust the offset. The
camera continues to adjust the offset unless the user unchecks the auto offset; in that case the offset is
left off.
When the offset is changed the software does not confirm new setting with an acknowledgement. It is
necessary to click on the “Report” button to refresh the screen if you want to confirm the new setting.
FIGURE 19. R Auto Offset box is checked only while the camera sets the command.