Filter
Top Products
Page 25
Installation
TM/TMC-4200CL Series Progressive Scan Cameras
5.2.3 Camera Link Cable
The 26CL-02-26 cable assembly has been standardized as the Camera Link cable. This cable has a 26-
pin connector on both ends. This is a straight-through cable and the pin-out configuration is shown in
Table 2 on page 24. Contact JAI for cable lengths other than 2 meters.
FIGURE 39. 3M Camera Link Cable
Note: For CL versions, serial communication for camera control is accomplished by means of
the Camera Link connector on the rear panel of the camera.
5.2.4 Power Supplies and Power Cable Setup
5.2.4 (a) Power Supplies
The TM-4200CL camera requires 12V DC power that is obtained through the 12-pin connector located
on the rear panel of the camera. JAI recommends the following power supplies:
PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply,
US Plug
PD-12UUP PD-12UU with12-pin connector US plug
PD-12UE PD-12UU European plug
PD-12UEP PD-12UU with 12-pin connector European plug
For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP
power supplies are available with the 12-pin mating connector already attached to the leads from the
power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI power cable by
means of a terminal strip or directly.
When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:
• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
• Use shrink tubing or a similar insulator to prevent exposed leads from touching and shorting.
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug
Cable
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug
2X
Thumbscrews
2X
Thumbscrews
1
23
14
15 16
11
12 13
24
25 26
4
56
17
18 19
7
89
20 21
22
10
23
1
23
14
15 16
11
12 13
24
25 26
4
56
17
18 19
7
89
20 21
22
10
23