Filter
Top Products
Page 13
Graphical User Interface
Dual-Tap TM-4200CL AccuPiXEL Series Camera-Control Software
Tap Selection:
The TM-4200CL is capable of Dual-Tap or Single-Tap operation. Click the option button for the
operation you prefer. Single-Tap operation does not allow the higher data rate permitted by the Dual-
Tap output.
FIGURE 20. Click the corresponding option button to set the tap.
3.3.5 Video Depth
Use the option buttons to select 8-bit, 10-bit, or 12-bit output.
FIGURE 21. Click the option button to select Video Depth.
3.3.6 Image Pre-Processing
To activate this control click the “Blemish Calibration” button and then check the “Enable Blemish
Compensation” check box. The blemish compensation activates. The lens must be covered with the lens
cap during calibration.
Note: Blemish Calibration is necessary only after a camera has been powered off and restarted.
Once enabled, blemish compensation remains active unless the user unchecks the
“Enable Blemish Compensation” checkbox.
FIGURE 22. Checking “Enable Blemish Compensation” activates Image Pre-
Processing.
3.3.7 Ctrl Signals
Use the option buttons to select the control signal that matches your cabling setup, either CL or 12Pin
FIGURE 23. Set “Ctrl Signal” by clicking the option button matching your cabling.