Filter
Top Products
141
Configuring the system remotely
PTZ Menu
The system is capable of manipulating PTZ cameras (not included) that are connected to
the system. Please note that you will need PTZ information from the PTZ manufacturer’s
users guide.
To configure the PTZ Parameters menu:
1 Cl
ick REMOTE CONFIG>Device>PTZ Parameters.
2 Co
nfigure the following:
• Channel: Sel
ect the channel that the PTZ camera connects to
• Protocol: Select the protocol of the PTZ camera*
• Baud Rate: Select the baude rate of the PTZ camera*
• Data Bits: Select the data bit rate of the PTZ camera*
• Stop Bits: Select the stop bit rate of the PTZ camera*
• Verify: Select from Odd, Even, Mark, or Space.*
• Cruise: Select enable or disable.*
• Address: Select the address of the PTZ camera*
*Consult the PTZ camera’s instruction manual for protocol and configuration details
Optional: Cl
ick the Copy Settings To button to copy the PTZ settings to different channels.
3 Cl
ick Save to apply your settings.
• For details on connecting a PTZ camera to your system,
see “Appendix H: Connecting a PTZ
Camera” on page 112.
PTZ Parameters