Filter
Top Products
71
Remote Viewing
Configuring Alarm Parameters
The Alarm parameters menu allows you to select the type of events that will trigger the
system to "beep" during an alarm event.
To configure alarm parameters:
1 Cl
ick Remote Setting>Alarm>Alarm Parameters.
2 Co
nfigure the following:
• Buz
zer Time: Select the duration the system beeps if the DVR detects an alarm event. Choose
from 10 - 60 seconds.
• Select the type of events that will trigger an alarm:
• MD Al
arm (motion detection)
• HDD Los
s: Hard Drive loss
• HDD Spac
e: Low Hard Drive Space
• Vi
deo Loss
• Select the Ema
il check box if you want the system to send e-mail notifications if the system
detects alarm events.
• Select the Full Screen check box if you want the system to go into full screen mode when the
system detects alarm events.
• Post Recording: Select the post recording time after an alarm event triggers the an alarm.
• Pre Record: Select the pre recording time when the system detects an alarm trigger.
3 Cl
ick Apply to save your settings.