Filter
Top Products
21
Recording
By default, the system is set to immediately record video from connected cameras in
Continuous Recording Mode.
• Recording—Continuous: Normal, c
ontinuous recording
You can set the system to stop recording once the hard drive is full, or to continually record
by
overwriting previously recorded data. For more details, see “Configuring Hard Drive
settings” on page 42.
Event Recording
The system also includes motion recording:
• Reco
rding—Motion: The system records when motion is detected by the camera
Recording Audio
The system can also record audio for each channel (
4/8/16 audio channels depending on
your respective model
).
To enable audio recording:
1 Co
nnect the BNC video cable from the camera
to one of the BNC ports on the rear panel of the
system. For example, connect the camera to
BNC port
1.
2 Co
nnect the RCA audio cable from the camera
to the corresponding audio channel. Following
the example in step 1, you would connect the
cable to audio port 1.
3 Open
the Main Menu and click RECORD.
4 Under AUDIO, sel
ect ENABLE.
5 Cl
ick APPLY.
6 Cl
ick EXIT in all menus until all windows are closed.
NOTE: 16-channel models
require an audio-harness. For details, see “Appendix J:
Recording Audio” on page 115.
C
.
M
ATTENTION: Audio capable cameras (not included) or self-powered microphones
are required in order to record audio on the system.
*8-channel model shown
Connect an RCA
audio cable into
the AUDIO INPUT
ports.