Filter
Top Products
If trouble is detected immediately after the power is turned on or during operation, the display window (LCD), WARNING lamp,
lamps inside the viewfinder, and warning tones from the speaker and earphone inform the operator of trouble.
Display window (LCD)
Lamps
Item
RF
Remain-
Remain-
Warning
Warning
ing
WARN-
REC
display
battery
ing tap
e ING
display
status
level
length
lamp
lamp
display
display
Warning
tone
Warning
contents
RF
Lighted
*
1)
Emitted
Flashes
Flashes
4 times
Video head
4 times 4 times
clogging,
per
per
per
second
recording
second
second
*1)
system trouble
SERVO
SERVO
Lighted
HUMID
HUMID
Lighted
SLACK
SLACK Flashes
Flashes
Flashes
Emitted
4 times 4 times 4 times The servo is
per
per
per
out of order.
second
second
second
Emitted
4 times
Flashes
second
Lighted
4 times
*1)
Condensation
second
Continu-
ous
tone*2)
Flashes Flashes
Continu-
4 times
4 times ous Tape wind-up
per
per
tone trouble
second second
VTR (section)
operation
Head clogging is
detected and a
warning tone
emitted. Images
may not be
recorded properly.
Recording
continues, but
images may not
be recorded
properly.
Recording
continues, but
stops if tape
sticking occurs.
Playback, fast
forward and
rewind operation
stops.
An error code
appears in the
time code display
position of the
display window
(LCD) and the
VTR stops.
Countermeasures
Clean the heads.
If images still
cannot be
recorded properly
after the heads
are cleaned,
consult your
dealer.
Turn off the power
and consult your
dealer. (Lamps
may flash briefly
and then go off
when tape running
starts, but this
does not indicate
trouble.)
If tape running
stops and the
HUMID display
does not go off
even when the
power is turned off
and then on again,
wait until the
display goes off.
Check the error
code in the display
window (see
page 127) and
consult your
dealer.
*1) During recording
*2)
During playback, fast forward or rewind
<Note>
If a cleaning tape is not available to deal with video head clogging, etc., first estab-
lish the STOP mode and then press the STOP button again while the RESET but-
ton on the side panel is kept depressed. While these buttons are held down, the
cleaning roller will clean the heads for a maximum of 10 seconds.
-125
-
Warning System
per
per