Filter
Top Products
Setup Card Operations
Reading out data stored on cards
1
Set the MENU SET/OFF switch to SET. The page on which the previous setting menu opera-
tions were completed appears on the viewfinder screen. (When the menu is used for the first
time, the first page appears.)
2
Press the PAGE switch repeatedly until the SET UP CARD page shown below appears. (This
operation can also be performed using the PAGE+UP/DOWN function.)
– SET UP CARD –
READ ( CAM)
WRITE ( CARD)
CARD CONFIG.
ID READ/WRITE :ON
FUNCTION1~2R/W:ON
L/M/H SET R/W :ON
LEVEL 1~6 R/W :ON
3
Press the SHIFT/ITEM button to move the cursor to the READ ( CAM) position.
4
Press the UP (or DOWN) button. When readout is complete, the message shown below ap-
pears.
– SET UP CARD –
READ ( CAM)
WRITE ( CARD)
CARD CONFIG.
ID READ/WRITE :ON
FUNCTION1~2R/W:ON
L/M/H SET R/W :ON
LEVEL 1~6 R/W :ON
READ OK
5
When menu operations have been completed, set the MENU SET/OFF switch to OFF. The
setting menu disappears from the viewfinder screen and the displays indicating the unit’s cur-
rent status based on the data read out from the setup card appear at the top and bottom of
the viewfinder screen.
When data is not read out
If the following error messages appear when the UP (or DOWN) button is pressed in step 4, the
data is not read out.
Data readout error messages
Error message
NO CONFIG
NO CARD
ERROR
Condition
The setup card is not
formatted.
A setup card is not
inset-ted.
Data cannot be read out.
Countermeasure
Format the card.
Insert a card.
Data written by devices
other than this unit cannot
be read out.
-
86
-