Filter
Top Products
ECU REMOTE (remote control) connector (6-pin)
Connect the AQ-EC1 extension control unit (option) here.
<Note>
The POWER switches on unit and extension control unit must be set to OFF before the remote
control cable is connected or disconnected.
VIDEO IN connector (accessory)/26-pin output adaptor (option) mount
VIDEO IN connector (accessory)
(See below for the mounting method.)
The composite video signals are supplied here. It is used for checking the return signal and
recording external input signals.
<Note>
When recording signals input from an external source, recording can only be assured for stan-
dard signals.
26-pin output adaptor (option)
(See page 98 for mounting method.)
The 26-pin output adaptor AJ-YA700P (option) is mounted on this section. When the portable
VTR is connected as the external VTR, recording can be performed simultaneously with the
unit’s built-in VTR.
VIDEO OUT connector (BNC)
This outputs the video signals (75 termination, rated level) to be monitored. During recording,
EE images can be monitored; during playback, playback images can be monitored.
While performing settings on the menu, the setting menu can be superimposed onto the shot
images appearing on the monitor screen so that the settings can be checked (in which case,
the images appear in black and white).
CAM OUT (camera output) connector (BNC)
This outputs the composite video signals (75 termination, rated level). When a video monitor
is connected, the images shot by the camera can be monitored. Even while the VTR is playing
back, the camera’s images are output at all times.
Mounting the VIDEO IN connector
Remove the blank panel and mount the VIDEO IN connector.
Connect the 2P connector.
-17-