Filter
Top Products
Protecting stored data
If the setup card’s WRITE PROTECT switch is set to ON, data is not rewritten even if the UP (or
DOWN) button is pressed in step 4.
Set to ON.
When data is not written
If the following error messages appear when the UP (or DOWN) button is pressed in step 4, the
data is not written.
Data writing error messages
Error message
NO CONFIG
Condition
The setup card is not
formatted.
Countermeasure
Format the card.
NO CARD
A setup card is not
inserted.
Insert a card.
WRITE PROTECT
The write protect switch on
Set the write protect switch
the side of the card is set to
on the side of the card to
ON.
OFF.
ERROR
Data cannot be written on
the card.
The card may be defective.
Replace the card.
-
85
-