Filter
Top Products
Status Displays Inside the Viewfinder Screen
1
Extender display
This is displayed when the lens extender is being used.
2
Shutter speed/mode display
This displays the shutter speed or shutter mode setting.
OFF:
The shutter is not used.
1/100, 1/120, 1/250, 1/500, 1/1000, 1/2000:
Shutter speeds (seconds) during standard mode.
1/30.4–1/250 (SYNCHRO SCAN):
Synchro scan mode is selected.
SUPER V:
High vertical resolution mode is selected.
3
Remaining tape length display
This indicates the remaining tape length (minutes) for the VTR during recording.
Remaining tape length display
Display
Remaining tape
length
F–60
Full to 60 minutes
60–55
60
to 55 minutes
55–50
55
to 50 minutes
50–45
50
to 45 minutes
45–40
45 to 40 minutes
40–35
40
to
35 minutes
35–30
35 to
30 minutes
30–25
30
to 25
minutes
25–20
25 to
20 minutes
20–15
20
to
15
minutes
15–10
15
to
10
minutes
10–5
5–0
10 to 5 minutes
5 to 0 minutes
The “5–0” display flashes when there is
less than 3 minutes of tape remaining.
4
Remaining battery level display
When an Anton Bauer Digital Magnum Series battery is used to supply power to the unit,
the remaining battery level is displayed numerically (%).
5
Filter display
This displays the type of filter selected.
6
White balance memory display
This displays the selected white balance automatic adjustment memory.
A:
The WHITE BAL switch is set to A.
B:
The WHITE BAL switch is set to B.
P:
The WHITE BAL switch is set to PRST.
7
Gain value display
This displays the image amplifier gain setting (dB) set by the GAIN switch.
<Note>
When using an Anton Bauer Digital Magnum Series battery, the remaining battery level display
continues to display the level for the Anton Bauer battery even if power supply is switched to an
external power source near the end of the battery’s power. However, note that the unit operates
according to the external power source.
-
54
-