Filter
Top Products
Adjusting the White Balance/Black Balance
4
Adjustment is completed after a few seconds (the following message appears) and the ad-
justment value is automatically stored in the memory.
ABB OK
Message after adjustment is completed
<Notes>
Check that the lens connector is connected and that the iris of the lens is set to CLOSE.
During black balance adjustment, the iris automatically goes to the shaded status.
During black balance adjustment, the gain selector circuit switches automatically.
In addition, flicker and noise may appear on the viewfinder screen, but this does not indicate a
malfunction.
The black balance cannot be adjusted while the setting menu is displayed on the viewfinder
screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.
If black shading is not satisfactory even when ABB is OK, open the AUTO SHADING page of the
setting menu and execute black shading adjustment. (See page 124.)
-
70
-