Filter
Top Products
Lamp Displays Inside the Viewfinder
The viewfinder displays are as follows.
VTR SAVE
1. REC (recording) lamp
This lamp lights (red) during recording, and flashes when warnings are issued.
See “Warning System” (page 125) for a detailed description.
2. BATT (battery) lamp
When the battery voltage has dropped, this lamp begins flashing several minutes before the
unit can no longer be operated, and lights when the unit can no longer be operated.
To prevent operation from being interrupted, exchange the battery quickly before the battery
runs out.
3. ! (irregular operation status warning) lamp
This lamp lights when the unit enters irregular operation status for any of the items set to ON at
the ! LED page of the setting menu. Applicable items are as follows.
Setting item
Gain (0 dB)
Gain (–3 dB)
SHUTTER switch
WHITE PRESET switch
Lens extender
Filter control
SUPER V switch
Setting contents
The gain is set to a value other
than 0 dB.
The gain is set to a value other
than –3 dB.
The switch is set to ON.
The switch is set to PRESET.
The lens extender is being used.
The control is set to a value other
than 1.
The switch is set to ON.
See “Setting the ! Lamp Display” (next page) for selecting ! lamp display items.
4. VTR SAVE (VTR power saving) lamp
This lamp lights when the VTR SAVE/STBY switch is set to SAVE. It is not lighted during re-
cording.
<Note>
Regardless of the VTR SAVE/STBY switch, the unit automatically enters the SAVE state and the
lamp lights either after two minutes when in the stopped state, or after the length of time set for the
pause timer (the pause time) when in the paused state.
-51-