Panasonic AW-RP50N Camera Accessories User Manual


 
9
Installation precautions
q In addition to heeding the points presented in the “Safety precautions”, observe the
following precautions as well.
Be absolutely sure to ask your dealer to do the jobs of installing and connecting the unit.
Connecting the power supply
p Use within AC 100 V to 120 V.
p Be absolutely sure to use only the
power cord and AC adapter supplied
with the panel.
p Be absolutely sure to connect the
grounding terminal of the power cord
to ground.
p Be absolutely sure to connect the ground terminal
(SIGNAL GND) at the rear of the unit to the system
ground.
p To prevent the DC plug from being disconnected, secure
the cable of the AC adapter to the cable clamp.
p When the unit is not going to be used for a prolonged
period of time, turn off its power, and disconnect the
power plug from the AC outlet.
LAN
SV
NM
BOOT
12V
POWER
ON
1
Cable clamp
Handle carefully!
p Dropping the unit or subjecting it to strong impact or
vibration may cause trouble and/or malfunctioning.
Do not allow any foreign objects to enter inside
the unit!
p Allowing water, metal items, scraps of food or other
foreign objects inside the unit may cause a fire and/or
electric shocks.
Choosing the best installation location
p This unit is designed for indoor use only.
p Install the unit on a sufficiently strong, stable and level
surface for use.
p Ensure a space of at least 100 mm (3-15/16˝) around the
rear vents to avoid obstructing ventilation.
In particular, ensure sufficient space between ventilation
and wiring when using mounted in a panel or table.
p Do not install the unit in a cold place where the
temperatures will drop below 0 °C (32 °F) or in a hot
place where the temperatures will rise above 40 °C
(104 °F).
p Avoid installing the unit where it will be exposed to direct
sunlight or to the hot air that is blown out from other
products.
p Installing the unit in a very humid, dusty or vibration-
prone location may give rise to trouble.
Ventilation holes