Filter
Top Products
27
Connections
q When introducing additional remote
cameras or a switcher into an
environment where similar existing
devices are already in use
Even when additional remote cameras or switchers are
introduced into an environment where similar existing
devices are already in use, the settings can be easily
established using “Auto IP setting”.
The operating procedure is the same as for “When setting
the IP addresses for the first time”. Refer to this section.
The settings can also be established without changing the
network settings (IP address, subnet mask and default
gateway settings) of the additional remote cameras and
switcher which will be introduced.
Refer to “When leaving the network settings of the additional
devices to be introduced unchanged”.
When leaving the network settings of the additional
devices to be introduced unchanged
1 Connect the additional remote cameras and
the switcher to be introduced and the unit to
the network within the same subnet.
2 On the [SYSTEM] menu, select [AUTO SET
IP], and display [AUTO SETUP]. Then select
“KEEP”, and press the F2 dial.
1.AUTO SETUP
KEEP
The total number of all the remote cameras and
switchers as well as the total number of the remote
cameras and switchers scheduled to be added, which
are the target of “Auto IP setting”, are displayed.
C:20/50 S:1/1
YES
C:20/50
Number of units connected within the
same network
Remote cameras and switchers scheduled
to be added
C: Remote camera, S: Switcher
When the total number of remote cameras and
switchers scheduled to be added exceeds the total
number of units which can be registered (remote
cameras: 100 units; switchers: 1 unit), the [C/S OVER!]
message appears on the bottom line of the LCD panel.
Auto IP setting can still be initiated this state, but the IP
addresses will be set only for the number of units which
can be registered.
C:20/20 S:1/1
C/S OVER! YES
Memo
The camera numbers whose IP addresses have been
set using “Auto IP setting” will be set to “NetWork” for
their connection setting. Consequently, when “Auto IP
setting” is next initiated, these camera numbers will be
excluded from being targeted by the setting.
However, when the IP addresses of camera numbers
whose IP addresses were set using “Auto IP setting”
have been changed or the connection setting has been
changed to “NoAsign” or “Serial”, they will again be
targeted by “Auto IP setting”.