Panasonic AW-RP50N Camera Accessories User Manual


 
31
Selecting the remote cameras to be operated
Up to five remote cameras to be operated can be selected
using the CAMERA STATUS/SELECTION buttons.
When one of the CAMERA STATUS/SELECTION buttons
1 to 5 is pressed, the indicator of the corresponding button
lights.
The statuses of the remote cameras assigned to CAMERA
STATUS/SELECTION buttons 1 to 5 can be identified by the
lighting statuses of the indicators above the buttons.
R/B GAIN R/B PED
SYSTEMSETUPCAMERA
SCENE/MODE
DETAIL
DELETESTORE
PAGEMENU F2 EXIT
USER2USER1
PT ACTIVEAUTOIRIS
CAMERA STATUS / SELECTION
PRESET MEMORY / MENU
GAIN/PED
123
AWB/ABB
4
SHUTTER
5
12345
678910
Indicator lighting statuses and remote camera statuses
Indicator
lighting status
Remote camera status
CAMERA STATUS/SELECTION button
operation
OFF
p No remote camera has been assigned to the corresponding button.
p No power is supplied to the remote camera.
p The LAN cable is not connected.
Disabled
ON
(orange)
The remote camera is in the standby status.
Enabled
Blinking
(orange)
Five other controllers are connected to the remote camera so the unit cannot
be connected.
Disabled
ON
(green)
The unit is now connected with the remote camera.
Enabled
Blinking
(green)
Another device has selected the corresponding remote camera.
Enabled
ON (red) The image of the corresponding remote camera is now on the air. Enabled
Blinking
(red)
Another device has selected the corresponding remote camera, and the
image of the camera is now on the air.
Enabled
Up to 100 cameras can be divided into 1 to 20 groups by
menu operations, and controlled by the unit.
The selection procedure is described below.
1 Set the MENU button to ON.
Press the MENU button and light its indicator.
2 Set the PRESET MEMORY/MENU 8 BUTTON
(CAMERA) to ON.
When the button is pressed and its indicator is lighted,
the [CAMERA] menu is displayed on the LCD panel.
[1]GROUP ▼
3 Press the F1 dial.
The GROUP SELECT item is displayed.
[1]GROUP ▼
1.GROUP SELECT
1
Press the F1 dial.
4 Turn the F2 dial, select the group, and then
press the F2 dial.
The remote cameras assigned to the group selected here
can be selected using the CAMERA STATUS/SELECTION
buttons.