Filter
Top Products
17
management enable command is factory set to yes, which allows the
remote configuration of the Model 2120 over the LAN.
Model 2120 Software Command System
The Model 2120 Software Command System is designed with a series of
help menus and commands derived from the actual function descrip-
tions. Once a session has been established with the 2120 and the sys-
tem prompt (
TS>
) appears, the main help menu (see Figure 4) will be
displayed by pressing the <
Enter
> key.
*** Help Menu ***
activateimage - Activate Image Acquired With FTP Get
boot - Boot System
configure - Configure Parameters
eiaconclose - EIA232 Connection Close
ftp - FTP To Remote Device
ping - Ping Remote Device
rawtcp - Raw-TCP To Remote Device
show - Show Parameters and Statistics
telnet - Telnet To Remote Device
Figure 4.
Main Help Menu
The "configure" and "show" commands are used to access system,
eia232 and user database related parameters. Commands other than
"configure" and "show" result in executing an operation or utility and thus
do not have menus associated with them.
Model 2120 Help Menu/Command Hierarchy
The help menu/command hierarchy is shown in Figure 5 on page 18.
Note
For a detailed definition of all Model 2120 system commands,
valid entries, and defaults see Appendix B on page 59.