Patton electronic 2120 Security Camera User Manual


 
21
Connection Retry Frequency: 0 (seconds)
Local Port: 404
Remote IP Address: 1.1.1.8
Remote Port: 23
Remote Password: UNDEFINED (no entry)
Remote User ID: UNDEFINED (no entry)
Session Termination Character: 0x04 (Control-D)
System Defaults
Boot Message Display Enable: yes
Default Gateway IP Address: 0.0.0.0 (disabled)
Unit DHCP Enable: yes
Unit IP Address: 5.5.5.5
Unit MAC Address: (Factory Assigned MAC/NIC Address)
Management Enable: yes
Management Inactive Timeout: 15 (minutes)
Prompt: TS>
Unit Subnet Mask: 255.255.255.0
User Database Defaults
user database empty!
Note To reset the Model 2120 software to factory default settings, set
internal dip switch #1 to the ON position and power cycle the
Model 2120 unit. Once powered on, set switch #1 back to the
OFF position. This will reset all settings, with the exception of the
unit MAC address, to the above listed factory defaults.
3.4 INITIAL UNIT CONFIGURATION
Unless pre-configured with an IP address for your LAN (not standard),
the Model 2120 must be initially configured via the serial interface using
the menu-driven command system and required terminal equipment as
described below: