67
Default:
yes
Valid Entries:
yes, no
Note Set to NO if the serial device is affected/confused by the boot
message.
configure system defgatewayipddr
X
Sets the IP address of the default gateway.
Accessibility:
READ/WRITE
Default:
0.0.0.0 (disabled)
Valid Entries:
Any in MAC address format
Note The 2120 will attempt to find and use the MAC address of the
default gateway when the MAC address of the destination IP
address cannot be found.
configure system dhcpena X
Permits DHCP client operation.
Accessibility:
READ/WRITE
Default:
yes
Valid Entries:
yes, no
Note When set to YES, the 2120 will automatically request and use
an IP address assigned by a DHCP Server as the IP Address of
the 2120 unit. This feature will not function unless there is an
active DHCP Server on the LAN.
configure system helpmenudispena X
Help menu display enable
configure system ipaddrcfg X
Sets IP address of the 2120 unit.
Accessibility:
READ/WRITE
Default:
5.5.5.5
Valid Entries:
Any in IP address format.
Note If there is an active DHCP Server on the LAN, "configure system
dhcpena" must be set to NO or the IP address of the 2120 unit
entered here will be overwritten with the IP address assigned by
the DHCP server.
configure system mac
X
Changes MAC address of the 2120.
Accessibility:
READ/WRITE
Default:
Factory assigned MAC/NIC address.
Valid Entries:
Any in MAC address format.
Note MAC address can be changed, but will not reset when hard (Dip
Switch #1) or soft (configure resetnv) configuration resets are
performed.