Filter
Top Products
61
configure eia232 interface dtedce
X
Sets the RS232 Physical Port of the serial interface.
Accessibility:
READ/WRITE
Default:
DCE
Valid Entries
: DCE, DTE
configure eia232 interface flowcontrol
X
Sets the RS-232 Flow Control of the serial interface.
Accessibility:
READ/WRITE
Default
: none
Valid Entries:
none, hardware, xonxoff
configure eia232 interface inactiveto X
Sets the period of time (in minutes) that the 2120 will close an inactive
connection to the serial interface.
Accessibility:
READ/WRITE
Default:
15 (minutes)
Valid Entries:
0-10080
Note Entering a 0 for this parameter will disable this feature and allow
a connection to the serial interface for an unlimited period of
time.
configure eia232 interface ipaddrcfg X
Sets the static IP address used to conduct PPP or SLIP operations.
Accessibility:
READ/WRITE
Default:
8.8.8.8
Valid Entries:
Any in IP address format
Note For SLIP operations, this IP address must be configured with
the same IP address configured in the device connected to the
serial interface.
configure eia232 interface parity
X
Sets the RS-232 Parity of the serial interface.
Accessibility:
READ/WRITE
Default:
none
Valid Entries:
none, odd, low, even, high
configure eia232 interface protocol
X
Sets the protocol used by remote devices to communicate with the
2120’s serial interface over the LAN.
Accessibility:
READ/WRITE
Default:
telnet
Valid Entries:
telnet, rawtcp, PPP, SLIP
configure eia232 interface rxidlechartrig
X
Receive idle character for trig <num char>.