Filter
Top Products
Setting the illumination color
The illumination color can be selected from 10
different colors. Furthermore, the illumination
color can be switched between these 10 colors
in order.
1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “RGB Il-
lumination”.
3 Press MULTI-CONTROL left or right to
select the desired color.
White (white) — Light Green (light green) —
Green (green) — Light Blue (light blue) —
Blue (blue) — Yellow (yellow) — Amber
(amber) — Red (red) — Scan (scan) — Cus-
tom (custom)
! Scan:
Shifts between the eight default colors in
sequence gradually.
! Custom:
Sets your createdcolor which is installed
from SD asthe illumination color.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
the navigation system as the one of sources.
Activate the auxiliary setting when using aux-
iliary equipment connected to the navigation
system.
1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “AUX”.
3 Press the center of MULTI-CONTROL to
switch between “On” and “Off”.
Setting the rear output and
subwoofer controller
The navigation system’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch S/W Control to
Rear SP:S/W, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection
(Rear SP:F.Range).
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “S/W
Control”.
3 Press the center of MULTI-CONTROL to
switch between “Rear SP:F.Range” and
“Rear SP:S/W”.
When no subwoofer is connected to the rear
speaker leads directly, select
“Rear SP:F.Range” and proceed to the next op-
eration.
When a subwoofer is connected to the rear
speaker leads directly, select “Rear SP:S/W”
and finish the setting.
4 Turn MULTI-CONTROL to select “Pre-
out”.
5 Press the center of MULTI-CONTROL to
switch between “Subwoofer” and “Rear”.
When no subwoofer is connected or you want
to control the subwoofer sound with the exter-
nal amplifier, select “Rear”.
When a subwoofer is connected to the RCA
output, select “Subwoofer”.
En
125
Chapter
26
Customizing preferences
Customizing preferences