Pioneer CNSD-130FM Camera Accessories User Manual


 
1 Display the Audio Menu screen.
= For details, refer to Displaying the
Audio Menuscreen on page 126.
2 Turn MULTI-CONTROL to select
P.EQ Setting1.
3 Press MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time MULTI-CONTROL is pressed left or
right, the equalization band is selected in the
following order:
Low Mid High
4 Press MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time MULTI-CONTROL is pressed up or
down, the level of the equalization band in-
creases or decreases. +6 to 6is displayed
as the level is increased or decreased.
5 Turn MULTI-CONTROL to select
P.EQ Setting2.
6 Press MULTI-CONTROL left or right to
select the desired frequency.
Press MULTI-CONTROL left or right until the
desired frequency appears in the display.
Low: 40 Hz 80Hz 100 Hz 160Hz
Mid: 200 Hz 500Hz 1kHz 2 kHz
High: 3 kHz 8kHz 10kHz 12 kHz
7 Press MULTI-CONTROL up or down to
select the desired Q factor.
Press MULTI-CONTROL up or down until the
desired Q factor appears in the display.
2W 1W 1N 2N
8 Repeat above adjustments.
If necessary, you can adjust other equalization
bands successively.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the Audio Menu screen.
= For details, refer to Displaying the
Audio Menuscreen on page 126.
2 Turn MULTI-CONTROL to select Loud-
ness.
3 Press the center of MULTI-CONTROL to
turn loudness on.
Loudness level (e.g., Mid) appears in the dis-
play.
p To turn loudness off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pressed left or
right, level is selected in the following order:
Low Mid High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
1 Display the Audio Menu screen.
= For details, refer to Displaying the
Audio Menuscreen on page 126.
2 Turn MULTI-CONTROL to select Sub-
Woofer1.
3 Press the center of MULTI-CONTROL to
turn subwoofer output on.
p To turn subwoofer output off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
set the phase of subwoofer output.
Each time MULTI-CONTROL is pressed left or
right, the phase of subwoofer output is se-
lected in the following order:
Reverse (Reverse phase) Normal (Normal
phase)
5 Turn MULTI-CONTROL to select Sub-
Woofer2.
6 Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50Hz 63Hz 80Hz 100Hz 125Hz
En
128
Chapter
26
Customizing preferences