Filter
Top Products
ŝ207Ş
Setting the Exposure
3. Press the shutter release button halfway.
- Focus indicator ( ) appears in the viewfinder when focused.
4. Press the shutter release button fully.
- Three consecutive pictures will be taken, the first with no compensation, the second with negative
compensation, and the third with positive compensation.
(when the number of frames is set to [3]).
ƃ When the focus mode is set to SAF (Single mode), the focus is locked in the first frame position
and used for subsequent consecutive frames.
ƃ The auto bracketing exposure setting will remain effective for twice as long as the exposure
metering timer (default setting is 20 seconds) when you release your finger from the shutter
release button during auto bracketing, and you can take the next picture at the next compensation
value. In this case, auto focusing works for each frame. After about twice as much time as the
exposure metering timer (default setting is 20 seconds), the camera returns to settings for taking
the first picture.
ƃ You can combine Auto Bracket with the built-in flash or external flash (P-TTL auto only) to change
only the flash output continuously. However, when using an external flash, holding the shutter
release button down to take three continuous frames may cause the second and third frame to be
taken before the flash is fully recharged. Always take one frame at a time after confirming that
charging is complete.
ƃ Auto Bracket is not available when the exposure mode is set to B (Bulb) mode.
ƃ Auto Bracket and Multi exposure are not used at the same time.
INFORMATION
Taking Only Overexposed or Underexposed Pictures
You can use Auto Bracket mode for only underexposure or overexposure shots by combining the
operation with EV compensation (p.204). Auto Bracket is performed in both cases on the basis of
the specified EV compensation value.