Filter
Top Products
ŝ244Ş
Troubleshooting
Problem Cause
Remedy
Built-in Flash
does not
discharge
USB connection
with computer
does not work
properly*
USB connection
with printer does
not work properly
Shake
Reduction
does not work
When flash mode is
set to [Auto
discharge] or [Auto
flash+Redeye
reduct], the flash will
not discharge if the
subject is bright
The transfer mode is
set to [Printer]
An error occurred
while sending USB
data
The transfer mode is
set to [Computer]
Shake Reduction
function is off
Set flash mode to [Manual discharge] or [Manual
flash+Redeye reduct]. (p.70)
Set transfer mode to [Computer].
Change the transfer mode to [Printer].
Set transfer mode to [Printer]. (p.159)
Turn on the Shake Reduction switch.
Shake Reduction
function is not set
Properly
If a lens for which focal length information cannot be
acquired is used, set the [Focal Length] on the [ OPS]
menu.
Shutter speed is too
low for Shake
Reduction function
to be effective
when panning or
shooting night
scenes, etc.
Turn off the Shake Reduction function and use a tripod.
AE lock function
does not operate
Use AE lock with any setting other than (Auto),
(Bulb) mode or (Flash X-synchro) mode.
AE lock is not
available when set to
(Auto), (Bulb)
mode or (Flash
X-synchro) mode.