Filter
Top Products
Operator’s Manual LBA-PC
244
different camera than the
queue can be monitored with the EMAV bit in the status byte register (STB). This bit is set when
one or more messages is in the error message queue. This bit is cleared when the queue is
empty.
Note that you must set “:ERR Verbose=1” to receive error messages. If Verbose=0 then no messages will be put
into the error message queue and EMAV will remain clear.
Following is a list of possible remote error messages:
Message Error Type Description
Ibrd() time-out EXECUTION_ERROR LBA-PC was addressed to
listen. A time-out occurred
when the LBA-PC tried to read
from the bus. Any data
received will be discarded.
ibwrt() time-out EXECUTION_ERROR LBA-PC was addressed to talk.
A time-out occurred when the
LBA-PC tried to write to the
bus. The LBA-PC will attempt
to resend the entire response.
unrecognized
command
COMMAND_ERROR Command is unknown or not
supported, or attempt to set a
register that is read-only (ELR,
ESR, STB, etc.)
Bad int
parameter
COMMAND_ERROR Integer parameter missing or
unsupported format (binary is
not supported)
query not
allowed
COMMAND_ERROR A command was sent with a
question mark at the end, but
a query is not allowed
unrecognized
key
COMMAND_ERROR LBA-PC detected a key it does
not recognize. The LBA-PC
does not always detect such
keys.
cannot be set COMMAND_ERROR A key was specified whose
value cannot be set
Bad file name EXECUTION_ERROR The specified file or path does
not exist
Out of range RANGE_ERROR The indicated key=value is out
of range
contains no data EXECUTION_ERROR FRM,RDD - The requested
frame contains no data
different camera EXECUTION_ERROR FRM,LDD,SDD - The specified
frame was captured using a