Filter
Top Products
Saving and Loading Scene Files
136
Chapter 7 Saving and Loading User Setting Data
Scene files allow you to save the following types
of data.
• Values set in the PAINT menu
• Shutter speeds set in standard mode or ECS
mode
• White balance data
The data that is saved and loaded depends on the
setting of FILE >Reference >Scene White Data
in the setup menu.
To save a scene file to an S×S memory card,
insert the card into a memory card slot and then
proceed as follows.
See “Basic Setup Menu Operations” (page 91) for
information about menu operations.
1 Select FILE >Scene in the setup menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see “To assign names to files”
(page 135).
2 Select Scene Store Mem or Scene Store
S×S.
Select Scene Store Mem if you want to save
the data in the camcorder’s internal memory,
and select Scene Store S×S if you want to
save the data on an S×S memory card.
3 Press the MENU knob.
A list box of scene files appears.
File numbers where “No File” is displayed
are empty file numbers
4 Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5 To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Scene Store S×S in step 2, the
ACCESS lamp lights when you execute the
save.
When the data has been saved to the S×S
memory card, a completion message appears
and the ACCESS lamp goes out.
To load a scene file from an S×S memory card,
insert the S×S memory card into a memory card
slot, and then proceed as follows.
See “Basic Setup Menu Operations” (page 91) for
information about menu operations.
1 Select FILE >Scene in the setup menu.
2 Select Scene Recall Mem or Scene
Recall S×S.
Select Scene Recall Mem if you want to load
the file from the camcorder’s internal
memory, and select Scene Recall (S×S) if
you want to load the file from an S×S
memory card.
3 Press the MENU knob.
A list box of scene files appears. File
numbers where “No File” is displayed are
empty file numbers.
4 Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5 To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you selected Scene Recall S×S in step 2,
the ACCESS lamp lights when you execute
the load.
When the data has been loaded from the S×S
memory card, a completion message appears
and the ACCESS lamp goes out.
Saving and Loading
Scene Files
Saving Scene Files
Loading Scene Files