Filter
Top Products
Preparing a Power Supply
32
Chapter 2 Preparations
For safety, use only the Sony battery packs and
AC adaptors listed below.
• BP-GL95/GL65/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-DN2B/DN10 AC
Adaptor
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.
When a BP-GL95/GL65/L60S/L80S Battery
Pack is used, the camcorder will operate
continuously for the time shown below.
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1 Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
2 Slide the battery pack down until its
“LOCK” arrow points at the matching
line on the camcorder.
Chapter2 Preparations
Preparing a Power
Supply
Using a Battery Pack
Model name Operating time
BP-GL95 Approx. 310 minutes
BP-GL65 Approx. 210 minutes
BP-L60S Approx. 210 minutes
BP-L80S Approx. 270 minutes
1 BP-GL95/GL65/L60S/L80S
2 Align these lines.
1 “LOCK” arrow
2 Matching line on the camcorder