Filter
Top Products
Attaching the Viewfinder
33
Chapter 2 Preparations
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
Holding the release button in, pull the battery
pack up.
Notes
• During recording and playback (while the ACCESS
indicator is lit), be careful never to remove the battery
pack.
• Make sure to power the camcorder off before replacing
the battery pack.
Mount an AC-DN2B/DN10 on the camcorder in
the same way as a battery pack, then connect to
the AC power supply.
The AC-DN2B/DN10 can supply up to 100 W of
power.
CAUTION
When the viewfinder is attached, do not leave the
camcorder with the eyepiece facing the sun.
Direct sunlight can enter through the eyepiece, be
focused in the viewfinder and cause fire.
Note
When attaching the viewfinder, make notes of the
following points.
• Be sure to power off the camcorder before coupling the
viewfinder connector to the camcorder’s VF connector
(rectangular). If you make this connection when the
camcorder power is on, the viewfinder may not
function properly.
• Couple the viewfinder connector firmly to the
camcorder’s VF connector (rectangular). If the
coupling is loose, noise may appear on the video or the
tally indicator may not operate properly.
1 1 Loosen the viewfinder left-to-right
positioning ring, 2 attach the
viewfinder to the viewfinder fitting
shoe, and 3 tighten the viewfinder left-
to-right positioning ring.
Using AC Power
Release button
To an AC outlet
Attaching the Viewfinder
Attaching the Supplied Viewfinder
Stopper
Viewfinder left-
to-right
positioning ring