Filter
Top Products
21
Loading the Paper Roll and Ink Ribbon
Chapter 2 Preparations
7
Close the paper door, and press the center of the door
until it clicks into place.
• If you close the door by pressing only its sides, the
door may not lock into place properly.
• When closing the paper door, be sure that the front
edge of the paper is not caught in the door.
To load the ink ribbon
1
Pull the ribbon door toward you to open it.
2
Remove the ribbon tray.
After removing the ribbon tray, do not insert your hand
into the opening in the unit. Touching the protrusions
or movable parts inside the unit may result in bodily
injury or malfunction of the unit. In particular,
touching the thermal head when it is hot immediately
after printing may result in burns.
3
Detach the white spool of the ink ribbon from the black
spool.
4
Gently unravel the ribbon without loosening it, and
place it in the ribbon tray.
Place the white spool in the front holder and the black
spool in the rear holder as shown.
If the ink ribbon is loosely raveled around the spools
or there is any slack or creases in the ink ribbon, wind
the spools to tighten the slack and smooth out the
creases.
Notes
Note
Note