Filter
Top Products
32
Basic Settings Used in All Operation Modes
Chapter 3 Setup
Basic Settings Used in All
Operation Modes
This section explains the basic settings that are used in all
of the operation modes.
Selecting the Language
This procedure selects the language that is used for all of
the other settings and operations.
The factory default setting is English.
1
Open the Screens tab on the administration screen.
2
Touch the [1] button under [Language].
A list of languages appears.
3
Touch the language that you want to select, and then
touch the [OK] button.
The display changes to the selected language.
Specifying the languages available for
selection during operation
J Applicable modes: Full mode, Quick Print
mode
When using Full mode or Quick Print mode, it is possible
to specify up to five additional languages to be made
available for use during operation. If more than one
language is specified, the user can select one of the
languages when they start to place an order.
To specify additional languages to be made available for
use during operation, touch the [2] through [6] buttons and
select the desired language from the list that appears.
If a language is selected for one button, it is not available
for selection for another button.
To cancel a setting, touch [OFF] in the language list.
• Additional languages are not available in Event mode.
• The administration screen and error messages are always
displayed in the language specified in position [1].
• You cannot select [OFF] for position [1].
• If you only set position [1], the language selection screen
will not appear during orders.
If you want to change the positions of two selected
languages (for example, you have selected, “[1] English”
and “[2] Japanese,” and you want to change the settings to
“[1] Japanese” and “[2] English”), you need to first cancel
the setting of one of the languages.
1 Touch [2] and select [OFF] from the language list.
2 Touch [1] and then select “Japanese.”
3 Touch [2] and select “English.”
Notes
Hint