Filter
Top Products
Regulatory and Safety LükWerks User Guide
93
WALL/CEILING MOUNT
•
Affix the mount to the wall or ceiling using the instructions provided in this manual.
•
Ensure the camera cable is routed in such a way as to preclude accidental pulling the camera off the
wall or ceiling.
If, after falling, the camera exhibits degraded performance, has ceased operating, shows visible cracks or if
there is evidence that internal components have come loose, disconnect the camera from its cable and follow
the instructions in this manual for obtaining service repair.
EXPOSURE TO MOISTURE
The LukWerks equipment is designed to be used only in dry, indoor environments. Do not use this system near
water; for example, near a bath tub, washbowl, kitchen sink, or laundry tub, in a wet basement, or in or near a
swimming pool. Exposure to rain, mists, excessive humidity and liquid emersion will likely cause significant
degradation in system performance and utility. If any LukWerks component has been exposed to moisture,
immediately unplug all components from power outlets and allow the components to dry completely before
attempting to reinstall the equipment. If, after drying, the system exhibits degraded performance, disconnect
the system from all power sources and follow the instructions in this manual for obtaining service repair.
FIRE HAZARDS
Care should be taken to keep LukWerks equipment and packing material away from open flames and
temperatures in excess of 34°C (93°F). Care should be taken to keep electrically conductive objects from
falling between the Luk camera power supply and the LukWerks HomePlug®/USB Bridge and the wall plug,
potentially shorting out the AC power and causing a fire. If the case of any LukWerks equipment becomes
open, cracked or broken in any way disconnect the power source to the component and refer to the service
repair section of this manual.
SHARP EDGES
Under normal circumstances LukWerks system components are safe to handle. If the LukWerks components
are exposed to significant physical shocks, the LukWerks enclosures could break open exposing sharp
enclosure edges and sharp internal component edges. In the event of enclosure breakage, carefully remove
affected components from their power source and follow the service procedures of this manual.
CHOKING, SUFFOCATION AND STRANGULATION HAZARDS
Care should be taken to keep LukWerks equipment and packing material away from small children and
persons with diminished mental capability. Specifically, the camera lens might be unscrewed and accidentally
swallowed. The wall/ceiling mount screws and anchors could be accidentally swallowed. The LukWerks cables
could also be accidentally swallowed or become wrapped about a neck. If the LukWerks components are
exposed to significant physical shocks, the LukWerks enclosures could break open and small internal
components could come loose and become a choking risk. Plastic packing material may present a suffocation
hazard to small children and persons with diminished mental capability. Please properly dispose of all packing
material.
USE WITH THIRD PARTY DEVICES
Do not plug the LukWerks cables into any device other than the intended LukWerks components. Doing so
could damage the equipment and expose the user to fire and electrical shock hazards. The LukWerks
equipment is specifically NOT compliant with “power over Ethernet” standards such as IEEE 802.3af.
VENTILATION
Keep the area around LukWerks components free of materials that may obstruct airflow and proper ventilation
of the components. This system should never be placed near or over a hot radiator or heat register. This
system should not be placed in a built-in installation unless proper ventilation is provided.