Filter
Top Products
100
E
Editing
AV
IN/OUT
OUTPUT
AUDIO
L
R
You can add sound to the original sound on a pre-recorded tape from audio
devices (AUDIO IN) or with the internal or external microphone (MIC. IN). The
original sound will not be erased. For best results, add sound to tapes that
have been recorded with this camcorder in SP mode with 12-bit sound. If
there are non-recorded portions on the tape, or portions recorded in a mode
other than SP mode, or with 16-bit or 12-bit 4-channel sound, dubbing will
stop. If your tape has not been recorded in SP mode with 12-bit sound, we
recommend dubbing your original tape onto a blank tape using the MVX2i’s
analog line-in function, then dubbing audio onto the new tape. Make
absolutely sure to set the audio mode of the new tape to 12-bit and the
recording mode to SP.
To connect other audio devices:
Notes:
• Do not use the yellow video terminal.
• The AV terminal doesn’t put out any video, so connect the S-video
terminals and check your TV, or check the LCD or the viewfinder as you
add new sound. Always check the new sound with the speaker.
To connect an external microphone:
STV-250N
Stereo Video Cable
An audio device
(i. e. CD player)
: Signal flow
Audio Dubbing