Filter
Top Products
176
E
Additional
Information
Time zone, date and time are not set. This message
appears each time you turn the power on until you
set the time zone, date and time ( 51).
Battery pack is exhausted. Replace or charge the
battery pack. ( 158).
Replace the tape or change the position of the
protect switch on the cassette ( 17).
The camcorder stopped operating to protect the
cassette. Remove the cassette and retry the
operation from the beginning ( 163).
DV cable is not connected, or the connected digital
device is turned off ( 90).
Condensation has been detected in the camcorder
( 163).
Tape reached the end. Rewind or remove the tape.
Recording is made in a mode other than the SP
mode. Audio dubbing or AV insert not possible
( 98, 100).
Recording is made in 16-bit or 12-bit 4-channel
mode. Audio dubbing not possible ( 100).
Camcorder detected a blank section on the tape.
Audio dubbing or AV insert not possible
( 98, 100).
Displayed immediately after you start recording
when the video heads are dirty. Clean the video
heads ( 161).
You attempted to playback a copyright protected
tape ( 92).
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY PACK
CHECK THE DV INPUT
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE CASSETTE
The camcorder displays various caution phrases for approx. 4 seconds.
Caution Phrases
CONDENSATION
HAS BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[
REC MODE
]
CHECK THE CASSETTE
[
AUDIO MODE
]
CHECK THE CASSETTE
[
BLANK
]
HEADS DIRTY,
USE CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED