Filter
Top Products
111
E
Using a Memory Card
Recording Still Images onto a Memory Card
3
P
H
O
T
O
1
2
CARD TAPE
(
V
C
R
)
P
L
A
Y
C
A
M
E
R
A
O
F
F
You can record still images onto a memory card. In addition to the still
images you record directly onto the memory card, you can record images
from a tape in the camcorder, or images input via the DV terminal or AV
terminal onto the memory card.
• When you are using an SD Memory Card, make sure the protect switch is
set to allow recording.
• Make sure a memory card with enough memory available is inserted into
the camcorder.
• While the card access indicator flashes, do not disconnect the power
source or remove the memory card. Doing so could result in data damage.
1. Press and hold the small button on the POWER switch and
turn the POWER switch to CAMERA.
2. Move the TAPE/CARD switch to CARD.
• The number of images that can still be recorded on the memory card,
and other information appear in the display.
• The camcorder will turn itself off if you are using a battery and do not
operate the camcorder for more than 5 minutes. Set the POWER switch
to OFF and then back to CAMERA.
3. Press the PHOTO button halfway and hold it.
• Exposure is locked.
• During autofocus
F
flashes white in the display as the camcorder adjust
the focus and it is displayed continuously as a green mark when the
camcorder is ready to take the still image.
4. Press the PHOTO button fully down to record the still image.
•
F
disappears from the display. The shutter sound sounds and
simultaneously the display appears to close for an instant as if it were a
shutter releasing.
• The card access indicator flashes and the card access display appears in
the display (See
“The indicators that appear in the LCD display when LCD
MIRROR is turned on” on page 27)
.