Filter
Top Products
167
E
Additional
Information
Miscellaneous
Cause and/or what to do about it
• The remote sensor mode is set to
OFFB in the menu ( 49).
• The remote sensor modes of the
wireless controller and the
camcorder itself are different
( 49).
• The batteries are dead or not
inserted.
• Check the screen displays ( 171).
• External interference may cause the
camcorder’s microprocessor to
malfunction temporarily. If random
letters appear in the display or if
normal operation is interrupted,
remove and then replace the
power source.
• Remove the cable and then
reconnect it or turn the power off
and back on again.
• This is not a malfunction.
Problem
? The wireless controller does
not work.
? The power indicator is flashing.
? The camcorder malfunctions.
? The DV cable is connected
correctly, but there’s nothing in
the display.
? The camcorder becomes warm
during use.
? The image cannot be erased.
• You are using an SD Memory Card
and it is set for erasure prevention.
Change the position of the protect
switch.
• The memory card is full. Erase
images ( 130) or insert a new
memory card.
• You have reached the maximum file
number. Set the file numbering to
RESET through the menu ( 110)
and insert a new memory card.
• You are using an unformatted
memory card. Format the card
( 148).
• The image is protected ( 127).
• You are using an SD Memory Card
and it is set for erasure prevention.
Change the position of the protect
switch.