Filter
Top Products
when replacing two or more ink tanks.
For details on ink lamp flashing speed, see
Checking the Ink Status.
4. Prepare the new ink tank.
(1)
Take a new ink tank out of its package, pull the orange tape ( ) in the direction
of the arrow to peel it off, then remove the film (
).
Important
Make sure that the film is completely removed from the air hole (D).
If the air hole is blocked with the remaining film, ink may leak out or may not eject properly.
(2)
Hold the orange protective cap (E) as indicated in the figure below, then twist
and remove it from the bottom of the ink tank.
Remove the protective cap while holding it to prevent the ink from staining your fingers.
Discard the protective cap once it is removed.
Important
Do not touch the electrical contacts (F) on the ink tank. It can cause the printer to
malfunction or become unable to print.
Important
If you shake the ink tank, the ink may spill out and stain your hands and the surrounding area.
Be careful to handle the ink tank.
Do not squeeze the side of ink tanks as this may cause the ink to leak out.
Be careful not to stain your hands and the surrounding area with ink on the removed
protective cap.
Do not reattach the protective cap once you have removed it. Discard it according to the local
laws and regulations regarding disposal of consumables.
Do not touch the open ink port once the protective cap is removed, as this may prevent the ink
Page 45 of 437 pagesReplacing an Ink Tank