Filter
Top Products
Take-up reel
LED status
Issue Print job
interrupted?
Possible cause Possible solution
Blinking quickly Take-up reel is not
winding
Yes The sensor beam was
blocked for more than 3
seconds.
Make sure that the take-up
reel sensors are not blocked
by a strip of paper, the
collection bin if you are using
the Z6200 1.1m printer, or
any objects. See the following
graphic. Make sure that the
collection bin is placed
behind the foot brace.
Also ensure that the take-up
reel power switch is in the On
position.
Blinking slowly Take-up reel is not
winding
No The sensor cables are loose
or unplugged.
Ensure that the sensor cables
are correctly secured.
Solid red Take-up reel is not
winding
No There is too much resistance
on the take-up reel motor.
Ensure that the paper is not
winding too tightly. A loop-
shaping core should be
inserted and hanging as
shown in step 10 of
Use the
take-up reel on page 37.
Solid green Take-up reel is not
winding
No The take-up reel power switch
is in the Off position
Ensure that the take-up reel
power switch is in the On
position.
Solid green Take-up reel is
winding in the
wrong direction
No The take-up reel wind-
direction switch is in the
wrong winding position.
After 3 seconds, the printer
recognizes the problem and
interrupts the print job. See
the first error listed in this
table.
Flip the take-up reel wind-
direction switch to the correct
position.
The following graphic shows the take-up reel sensors and cable.
1.
Take-up reel sensor
2.
Take-up reel sensor and cable housing unit
ENWW
Take-up reel does not wind
163
Troubleshoot paper