Filter
Top Products
To configure the same network settings from the front panel, select the Connectivity menu icon ,
then Fast Ethernet or Gigabit Ethernet > Modify configuration.
You have various other options available from the Connectivity menu icon.
●
USB: view information about the USB connection
●
Jetdirect EIO: view information, configure and reset the Jetdirect connection
●
Advanced > Select I/O timeout: specify the number of seconds that an idle connection is
allowed to remain open, 270 is the default value, if set to zero, the timeout is disabled
●
Advanced > Allow SNMP: specify whether SNMP is permitted
●
Advanced > Embedded Web Server > Allow EWS: specify whether the Embedded Web
Server is enabled
●
Advanced > Web Services > HP Utility software: view the HP Utility software settings
●
Advanced > Web Services > Color and paper management: view the color and paper
management settings
Change the graphic language setting
You can change the graphic language setting from the HP Utility with the following steps.
1. Under Windows, select the Settings tab then Printer settings > Printing preferences.
Under Mac OS, select Configuration then Printer settings > Configure printer
settings > Printing preferences.
2.
Select one of the following options.
●
Select Automatic to let the printer determine which type of file it is receiving. This is the
default setting; it works for most software applications. You should not normally need to
change it.
●
Select HP-GL/2 only if you are sending a file of that type directly to the printer, without
going through a printer driver.
●
Select PDF only if you are sending a file of that type directly to the printer, without going
through a printer driver (with the PostScript/PDF upgrade).
●
Select PostScript only if you are sending a file of that type directly to the printer, without
going through a printer driver (with the PostScript/PDF upgrade).
●
Select TIFF only if you are sending a file of that type directly to the printer, without going
through a printer driver.
●
Select JPEG only if you are sending a file of that type directly to the printer, without going
through a printer driver.
You can change the graphic language setting from the front panel. Select the Setup menu icon
,
then Printing preferences > Select graphic language. Select the desired option and press the
OK key to set the value.
NOTE: If the graphic language is set from the HP Utility, it overrides the front panel setting.
26 Chapter 3 Personalize the printer ENWW
Personal settings